1. המצת אינו נדלק בעת ההצתה.
בעת ההצתה, צריך להיות ניצוץ פריקה ברור בין המצת לגוף המצת, אותו ניתן לראות בבירור ולשמוע קול פריקת ניצוץ ברור.
If the spark plug does not ignite, first check whether the ignition indicator light of the main control board is on for 1-2 seconds when the "test fire" button is operated to confirm whether the ignition control of the main control board is correct.
אם יש הצטברות פחמן על המצת יגרום גם שהמצת לא יתלקח, ויש צורך לנקות אותו.
לאחר מכן, בדוק את חבילת המתח הגבוה- המחוברת למצת, כמו גם את החיבור והחיבור שלהם.
החל DC3V (שתי סוללות רגילות) על קצה הקלט של חבילת המתח הגבוה-, ויש ליצור פריקת ניצוץ בין שני קווי המוצא של חבילת המתח הגבוה- (המרחק בין שני הקווים הוא 2-10 מ"מ), אחרת חבילת המתח הגבוה תינזק.
2. לא נפלט גז בעת ההצתה.
While operating the "Test Fire" button, you can use an open flame to ignite the ignition at the igniter of the CNC cutting machine, so as to confirm whether there is gas ejected during ignition.
If no gas is ejected, check the main control board and the solenoid valve indicator light according to the gas circuit fault inspection and troubleshooting method. If the indicator lights of the main control board and the solenoid valve are normal and there is no valve blockage, it is possible that the small hole of the gas nozzle on the igniter is blocked. The way to confirm the diagnosis is to loosen the nut under the adjustment knob on the igniter, put the knob in the water, and see if there is gas spewing out when it is ignited. If there is gas here and there is no gas where the igniter spits out, the gas nozzle must be blocked. The hole of the gas nozzle is very small, Ф0.4mm. The treatment method is to use a hacksaw blade to grind out a slender tip, and then use it to straighten the hole.